Setting The Clock; Using The On-Screen Displays - Pioneer S-DV535 Operating Instructions Manual

Getting started
If the noise level is too high, Noisy! blinks in
the display for five seconds. To exit and check
1
, press MCACC SET UP, or to
the noise levels
try again, press ENTER when Retry? shows in
the display.
The system now checks the microphone and
your speaker setup.
• If you see an Err MIC! or Err SP! message
in the display, there may be a problem with
your mic or the speaker connections. To try
again, press ENTER when you see Retry?
When the MCACC setup is complete, the
volume level returns to normal and Complete
shows in the display. The MCACC indicator
then lights to show that the MCACC setup is
complete and Acoustic Calibration EQ has
4
been activated.

Setting the clock

Setting the clock allows you to use the timer.
DVD MENU RETURN
TUNE+
ST– ST+
ENTER ENTER
BASS
TUNE–
MUTE
MODE
1 Press TIMER/CLOCK .
• If you are adjusting the clock, rather than
setting it for the first time, press TIMER/
CLOCK again.
2 If 'Clk ADJ?' isn't in the display, select it
with or , then press ENTER .
3 Use / to set the hour. Press ENTER .
Note
1 • If the room environment is not optimal for the auto surround setup (too much ambient noise, echo off the walls, obstacles
blocking the speakers from the microphone) the final settings may be incorrect. Check for household appliances (air condition-
er, fridge, fan, etc.), that may be affecting the environment and switch them off if necessary.
• Some older TVs may interfere with the operation of the mic. If this seems to be happening, switch off the TV when doing the
auto surround setup.
2 If this doesn't work, press MCACC SET UP, turn off the power, and check the problem indicated by the Err message, then try
the auto surround setup again.
3 If Complete doesn't appear, it is likely an error occured during the setup. Please check all connections and try again.
4 See Listening with Acoustic Calibration EQ on page 13 for more on this.
5 If you unplug the system from the wall outlet, or there is a power outage, you will need to set the clock again.
6 The screen saver will appear after five minutes of inactivity.
2
3
5
TIMER/
DIMMER SR+ CLOCK
4 5 6
SYSTEM
SETUP TEST TONE CH LEVEL
7 8 9 9
QUIET/
SURROUND ADVANCED MIDNIGHT
0
ENTER
CLR
DIALOGUE
SOUND
MAIN SUB SUB
4 Use / to set the minute then press
ENTER to confirm.
The display flashes to indicate the clock is set.
• Press TIMER/CLOCK anytime to display
the clock.

Using the on-screen displays

For ease of use, this system makes extensive
use of graphical on-screen displays (OSDs).
All the screens are navigated in basically the
same way, using the cursor buttons ( ,
) to change the highlighted item and
pressing ENTER to select it.
Important
• Throughout this manual, 'Select' means
use the cursor buttons to highlight an item
on-screen, then press ENTER.
Button What it does
HOME
Displays/exits the on-screen display
MENU
Changes the highlighted menu item
ENTER
Selects the highlighted menu item
RETURN
Returns to the main menu without
saving changes
Tip
• The button guide at the bottom of every
OSD screen shows you which buttons
you'll need to use for that screen.
01
, ,
6
7
En