Surround Sound And Other Settings; Using The System Setup Menu; Surround And Sound Setup Options; Lfe Attenuator Setting - Pioneer S-DV535 Operating Instructions Manual

05

Surround sound and other settings

Chapter 5
Surround sound and other settings

Using the System Setup menu

All the available settings in the setup menu are
listed in Surround and sound setup options
below. See the notes in each section for
additional information about the settings.
Follow the steps below to customize the
settings in the System Setup menu.
1 Press SYSTEM SETUP .
2 Use to choose the setting you want
to adjust.
The current setting is shown for each option as
you cycle through the display. See below for a
full list and description of each.
3 Use to adjust.
4 Repeat steps 2 and 3 for other settings.
5 When you're done, press ENTER to leave
the System Setup menu.

Surround and sound setup options

Using the Auto MCACC setup for optimal
surround sound on page 6 should give you the
best surround sound setup, but you may find
that by adjusting the following settings you can
improve the surround sound in your listening
room. The first setting in each section is the
default.
Note
1 • The System Setup menu is exited automatically after 5 minutes of inactivity.
• You can't change the Surround and sound setup options with the Recording Mode (page 30) switched on.
• The Speaker distance setting and DTS CD setting require additional steps. Read the sections on each for more details.
2 This setting works only with Dolby Digital and some DTS soundtracks. For other sources, you can create a similar effect using
the Midnight mode (see Using Quiet and Midnight listening modes on page 14).
22
En
Speaker distance setting
Specifies the distance from your listening
position to your speakers.
When Dist.? appears, press ENTER, then use
to adjust the distance, and
switch between the following speakers:
• L – Front left speaker
1
• C – Center speaker
• R – Front right speaker
• RS – Surround right speaker
• LS – Surround left speaker
• SW – Subwoofer
Each speaker can be adjusted between 0.3 m
~ 9.0 m. The default setting is 3.0 m.
Dynamic Range Control
Specifies dynamic range adjustment to Dolby
Digital or DTS soundtracks:
• DRC Off – No dynamic range adjustment
(use when listening at higher volume)
• DRC Mid – Mid setting
• DRC High – Dynamic range is reduced
(loud sounds are reduced in volume while
quieter sounds are increased)

LFE attenuator setting

Dolby Digital and DTS audio sources include
ultra-low bass tones. Set the LFE attenuator as
needed to prevent the ultra-low bass from
distorting the sound.
• LFEATT 0 – No attenuation
• LFEATT 10 – LFE channel attenuated 10dB
to
2