Instrument Case; Meter Replacement - Honda NX250 1989 Manuals

LIGHTS/METERS/SWITCHES

INSTRUMENT CASE

BULB REPLACEMENT
Remove the front fairing and the headlight case (page 1 9-3).
Remove the bulb socket from the case then replace the bulb
with a new one.

METER REPLACEMENT

Remove the fuel tank (page 4-3).
Remove the connector box cover and disconnect the meter
connectors.
• Speedometer
Disconnect the speedometer cable from the meter and discon-
nect the turn signal relay connectors from the reiay.
Remove the mounting bolts and free the case from the fairing
bracket, then remove the speedometer.
• Tachometer
If the tachometer does not work properly turn the ignition
switch ON and check the voltage between the Black and
Green wires at the 2P connector. There should be battery volt-
age. If not, check the continuity between the meter Black/
Yellow wire and the Black/Yellow wire at the CDI unit. If the
circuit is OK, check for a loose connector.
If the connector is OK, the tachometer is faulty.
If there is no voltage:
— Black wire open circuit
— Faulty tachometer
19-4
ID CONNECTORS .
1 SPEEDOMETER CABLE
(1) TACHOMETER
(2) TO IGNITION COIL
©
(4) BATTERY -A-
f3| C.D.I.
UNIT
e — |