Honda NX250 1989 Manuals page 68

HYDRAULIC BRAKE
Install the pivot boot on the caliper bracket and make sure that
the boot is seated in the groove properly.
properly.
Install the pivot boot on the caliper and make sure that the
boot is seated in the groove properly.
Install the pad spring.
Apply silicone grease to the pivot pins and install the bracket
on the caliper.
Install the pads (page 14-5).
Install the caliper on the fork leg and over the brake disc so that
the disc is positioned between the pads.
NOTE
• Use care not to damage the pads.
Tighten the caliper mounting bolls to the specified torque.
TORQUE: 25 N-m (2.5 kg-m, 18 ft-lb)
Install the brake hose to the calipe< with new sealing washers.
Tighten the brake hose oil bolt to the specified torque.
TORQUE: 35 N-m (3.5 kg-m, 25 ft-lb)
CAUTION
• Do not twin the brake hose. Be sure the brake hose is straight,
then connect it to the caliper.
Fill and bleed the hydraulic system (page 14-3}.
14-10
(2) RETAINER
{2) PAD SPRING
WASHERS \
(SILICONE)