Ferrari 612 Scaglietti Owner's Manual page 96

Air conditioning control switch B
Released
The air conditioner is on.
The air is cooled and/or only dehumidified according to
the temperature set.
2
Pressed (LED on)
The air conditioner is off.
However, heating is still enabled and will activate
according to the temperature set.
Air distribution controls C and G
They can operate in two modes:
Automatic "AUT"
The air flow distribution is controlled by the electronic
system, depending on the ambient conditions and the
temperature set.
Manual
This is used to direct the air flow in the six positions of the
respective areas (driver-passenger).
Temperature selection controls A and I
They are used to set the desired temperature in the
passenger compartment.
The "LO" and "HI" (minimum and maximum,
respectively) air temperature settings are activated at the
opposite end positions.
96
Fan speed control E
It has three operating modes:
Automatic "AUT"
The air flow is controlled by the electronic system,
according to the selected temperature to be reached and
maintained.
Manual "OFF"
Turn the control to this position to turn off the air
conditioning and to only allow air inlet from the outside
when the vehicle is moving.
Fan speed
The four setting positions allow the occupants to select the
air flow rate.
Residual heat function J
This function maintains the passenger compartment at the
set temperature for a period of time (15 minutes), even
with the key set to 0. To enable this function, press the
"REST" button before turning the key to 0. The system
uses the hot water recirculation pump and the lowest fan
speed setting to maintain the temperature.
If previously selected, this function will be enabled when
the key is turned to position 0 and it will go off after
15 minutes or when the key is turned back to position II.
The function will be disabled (if active), when the battery
voltage is below 11.5 V or when the outside temperature
is above 25 °C and it will not be possible to activate the
function in these circumstances.