Seat Belts - Ferrari 612 Scaglietti Owner's Manual

Storing the rear-view mirror position
In the models equipped with memory seats, every time the seat position
is memorised, the external rear-view mirror position is also stored
automatically, both for the normal travelling direction and for reverse
manoeuvring.
To memorise a new position of the external rear-view mirrors, turn the
ignition key to position II and adjust the position of the mirrors; then
engage reverse and reposition the external mirrors to ensure the best
possible visibility to perform the manoeuvre, then disengage reverse
gear.
Finally press one of the buttons 1, 2 or 3 on the seat, each one
corresponding to a memorisable position, until a double tone confirms
the procedure is complete.
The new position of the external rear-view mirrors will be automatically
memorised together with the seat position.
The mirror positions can be adjusted for both the normal travelling
direction and for reverse manoeuvring.
Never retract or open the mirrors by hand to avoid damaging the powering
mechanism.
The mirrors must always be in the open position while driving.
1 2 3

Seat belts

If used correctly, the seat belts in combination with the pretensioners,
protect the wearer from a variety of impacts, firmly securing the
occupants within the structure of the vehicle, thus preventing
dangerous jerks against the passenger compartment.
F urges you to ensure that your seat belts are
ERRARI
correctly fastened and adjusted at all times!
Correct use of the seat belts can reduce the risk of serious
injury in the event of an accident.
The seat belts are automatic with three fastening points and an
emergency inertia locking system on the winding unit, which is fitted
with a pretensioner.
For maximum protection, keep the backrest in the upright position,
ensure that your back is properly resting on it and adjust the seat belt
correctly, fitting it closely across your chest and pelvis.
The lap portion of the seat belt must be fitted low across your pelvis,
resting on the pelvic bones. Ensure that the lap portion of the seat belt
does not rest on the abdomen, as this can result in an increased risk of
injuries. Adjust the seat height to help keep the lap portion of the seat
belt low on the pelvis.
Do not let the seat belts come into contact with sharp
edges. They may tear. Do not pin anything to the seat
belts. This could reduce their initial strength and cause them
to tear in the event of a crash. Do not bring cutting edges in
contact with a seat belt.
This could reduce their initial strength and cause them to
tear in the event of a crash. If a seat belt has come into contact
with a sharp surface or has been used to pin something to it,
immediately have it replaced at the F
2
S N .
ERRARI ERVICE ETWORK
77