Ferrari 612 Scaglietti Owner's Manual page 137

Replacing a wheel
• Position the vehicle on an even surface, then engage 1st gear and lock
the rear wheels applying the parking brake.
• If necessary, turn on the hazard warning lights and place the hazard
triangle at the prescribed distance.
• Take the spare wheel and the toolkit from the luggage compartment,
located underneath the bottom panel.
• Loosen the five wheel stud bolts approximately half a turn each, using
the wrench supplied.
• Place the base of the jack on flat and firm ground in line with one of
the lifting points indicated underneath the vehicle floor.
• Raise the vehicle carefully, using the jack, until the wheel is lifted off
the ground.
If the jack is not positioned correctly, the vehicle could
slip off.
The jack supplied must only be used for replacing the
wheels.
• Completely unscrew the five stud bolts and remove the wheel.
• Fit the spare wheel and screw in the five stud bolts.
G G
• Lower the vehicle and remove the jack.
• Tighten the stud bolts completely, moving diagonally from one to the
next.
• Put the replaced wheel and the tools used back in the luggage
compartment and secure them so that they cannot knock against the
other devices in the luggage compartment.
As soon as possible, tighten the stud bolts with the torque wrench to
100 Nm.
spare wheel is not controlled by the system, but is conform to
the international regulations ECE R64/01. After fitting it, it
is advisable to go to the nearest A
C
ENTRE
G G
The spare wheel does not have the tyre pressure
monitoring sensor (see label on spare wheel bag). The
UTHORISED
.
G G
E
D
D Wrench
E
F
F
G Lifting points
F S
ERRARI ERVICE
Stud bolt
Jack
137
4