Before You Begin; Battery Installation And Removal - Yaesu FTA-450L Operating Manual

Battery Installation and Removal

 To install the battery, insert the battery pack SBR-
12LI into the battery compartment on the back of
the transceiver, press the end of the battery pack
while pressing the battery pack latch on the bot-
tom of the transceiver, then lock the pack by sliding
the locking plate beside the latch until the entire
"LOCK" appears.
Note:
Be sure that the rubber gasket on the SBR-12LI is
not loose when inserting.
 To remove the battery, turn the transceiver off, slide
the locking plate until the "UNLOCK" appears en-
tirely, lift up the end of the battery pack by pressing
the battery pack latch, then pull out the battery from
the radio.
12
B y
efore ou
Battery Pack
Latch
S H
P U
B
egIn
Do not attempt to open any of the recharge-
able Lithium-ion packs, as personal injury
or damage to the Lithium-ion pack could occur if
a cell or cells become accidentally short-circuited.
Note:
To remove the battery pack after the belt clip SHB-11
is mounted (see page 15), lift up the clip before you
press the battery pack latch.
FTA-450L O M
perATing AnuAL