Advertisement
Before You Begin. . .
6. Adjusting the Main Dial Torque
The torque (drag) of the Main Tuning Dial may be adjusted according to your preferences. Simply hold down the rear skirt
of the knob, and while holding it in place rotate the Main Dial itself to the right to reduce the drag, or to the left to increase
the drag.
H
S
OLDING THE
KIRT
T
T
IGHTEN
OOSEN
7. Restarting Power after a Voltage Fluctuation
If your AC mains power should suffer a significant fluctuation or interruption, we recom-
mend that you go through a complete power-up cycle, in order to ensure that all circuits are
properly initialized. To do this, be sure the front panel Power switch is turned off, then set
the rear-panel Power switch to the "O" position. Now unplug the AC cable from the rear
panel of the transceiver, and wait ten seconds. Plug the AC cable back in, set the rear-panel
Power switch to "O," and now press and hold in the front-panel Power switch for two
seconds to turn the transceiver on. After about 50 seconds, all circuits wil be initialized, and
normal operation may resume.
FT
9000D O
M
Page 6
DX
PERATION
ANUAL
Advertisement
