Before You Begin; Battery Installation And Removal - Yaesu FTA-850L Operating Manual

BEFORE YOU BEGIN

Battery Installation and Removal

 To install the battery, insert the battery pack SBR-
39LI into the battery compartment on the back of
the transceiver, press the end of the battery pack
while pressing the battery pack latch on the bottom
of the transceiver, then lock the pack by sliding
the locking plate beside the latch until the entire
"LOCK" appears.
Note:
Be sure that the rubber gasket on the SBR-39LI
is not loose when inserting.
 To remove the battery, turn the transceiver off,
slide the locking plate until the "UNLOCK" appears
entirely, lift up the end of the battery pack by press-
ing the battery pack latch, then pull out the battery
from the radio.
sonal injury or damage to the Lithium-ion pack
could occur if a cell or cells become acciden-
tally short-circuited.
Note:
To remove the battery pack after the belt clip SHB-11
is mounted (see Page 14), lift up the clip before you
press the battery pack latch.
Caution:
Risk of explosion if battery is replaced by an incor-
rect typ.
Dispose of used batteries according to the instruc-
tions.
Battery Pack Latch Plate
FCC ID: K6650033X30
IC: 511B-50033X30
Do not attempt to open any of the re-
chargeable Lithium-ion packs, as per-
13