Echo DSRM-2600 Operator's Manual page 27

1. Wear Indicators
Troubleshooting table
 For spare parts and consumables, please use only genuine parts and designated products and components.
Using parts from other manufacturers or non-designated components may result in a malfunction.
Trouble
Red Charger light flashes or does not
light up
Unit will not turn on
Unit does not run when turned on
Running time is too short
Line won't feed
Line fails to cut off
 Consult your dealer in the event of a problem that is not covered in the table above, or other such concerns.
 Please contact your dealer in order to dispose of the product or its parts in compliance with national laws.
Manufacturer:
YAMABIKO CORPORATION
1-7-2 Suehirocho, Ohme, Tokyo 198-8760 JAPAN
Authorized Representative in Europe:
CERTIFICATION EXPERTS B.V.
Amerlandseweg 7, 3621 ZC Breukelen, The Netherlands
IMPORTANT
When the wear indicators located at the bottom of the nylon
line cutting head are worn smooth, replacement of the cover or
the entire nylon line cutting head is required.
IMPORTANT
Cause
1. Plug not connected to power outlet
2. Battery pack not installed properly
3. Obstructed connection
4. Fault in the charger
5. Fault in the battery pack
1. Battery pack not installed properly
1. Battery pack discharged
2. Line head obstructed
3. Battery pack outside acceptable
temperature range
1. Battery pack outside acceptable
temperature range
2. Unit electronics too hot
3. Battery pack discharged
1. Not enough line on the spool
2. Line tangled in the spool
1. Cut off knife in the shield is damaged
or missing
25
Maintenance and care
1. Plug in the charger
2. Check the battery pack installation
3. Reinstall battery pack again after re-
moving obstructions from connec-
tion.
4. Consult your dealer
5. Consult your dealer
1. Check the battery pack installation
1. Charge the battery pack
2. Turn off the unit and clean the cut-
ting attachment
3. Remove the battery pack and allow
to cool
1. Remove the battery pack and allow
to cool
2. Turn unit off and allow to cool
3. Charge the battery pack
1. Rewind with new line
2. Unwind and rewind the line
1. Consult your dealer
Remedy