Operation; Starting The Unit - Echo DSRM-2600 Operator's Manual

 All over head electrical conductors and communications wires can have electricity flow with high voltages. This unit
is not insulated against electrical current. Never touch wires directly or indirectly, otherwise serious injury or death
may result.
 Do not operate the unit in explosive atmospheres, such as in presence of flammable liquids, gases or dust. The unit
creates sparks which may ignite the dust or fumes.
Be particularly careful to observe the following precautions when starting the unit:
 Check that none of the nuts and bolts are loose.
 A wrench or locking tool did not leave attached to a rotating part of the unit.
 Leave plenty of space around the product and do not allow people or animals near it.
Failure to observe the precautions could cause an accident or injury, or even lead to a fatality.
 Check that there are no abnormal vibrations or sounds once the unit starts. Do not use the product if there are ab-
normal vibrations or sounds. Contact your dealer to have it repaired.
Accidents involving parts that fall or shatter off can cause wounds or serious injury.
 Always switch off the unit and remove the battery when transporting the unit.
 Do not touch angle transmission and other high temperature components while the product is running
or for some time after it stops.
You could burn yourself if you touch a high temperature component.
 Never operate overreach the unit and to keep the balance at all times, to always be sure of the footing on slopes and
to walk, never run.
 Never to operate the unit with defective guards or shields, or without safety devices, or if the cord is damaged or
worn.
 Always ventilation slots (A) keep clean.

Starting the unit

 The attachment will operate when the battery is installed, the power indicator LED is lit, and the trigger switch and
trigger switch lockout are engaged. Make sure the product is properly positioned to prevent loss of control and pos-
sible serious injury.

Operation

DANGER
WARNING
IMPORTANT
WARNING
1. Check to ensure that the cutting attachment does not come
into contact with the surface of the ground or any other im-
pediment using a beam or other such implement.
2. Push power button (A) once to turn on power to unit.
 Power indicator LED (B) illuminates when power to unit is
turned on.
3. Hold down trigger switch lockout (C) and depress trigger
switch (D) to increase RPM to operating speed.
4. To increase speed, push + button (E).
5. To decrease speed, push - button (F).
6. There are three speed to be kept
7. If you press + button (E) for one second then keep the speed
at that time.
15
Operation