STEP 2) SPEAKER CONNECTIONS
SPEAKER CONNECTIONS (SPEAKER OUTPUT):
Speaker connections should be made using a minimum of 16 awg/1,25mm2 wire. The terminal accepts up to
8 awg/10mm2. Minimum total allowed impedance load is 1 – 2 ohm depending on model.
WARNING! DO NOT START the amplifier WITHOUT a load on the speaker output terminals.
Ignoring to do so can potentially result in a circuit failure in the start up mode sequence
and leave the amplifier stuck in protect mode (see specifications for correct impedance).
FIG 2: SPEAKER CONNECTION TWO CHANNEL AMPLIFIER
FIG 3: BRIDGED SPEAKER CONNECTION TWO CHANNEL AMPLIFIER
1-8 Ohm
1-8 Ohm
2-8 Ohm