Instructions; Installation Experience; Choosing Amplifier Mounting Locations; Installation Precautions - Bass Habit Elite SE550.2DF User Manual

INSTRUCTIONS

INSTALLATION EXPERIENCE

Installation of Bass Habit amplifiers may require experience with a variety of mechanical procedures including
cable wiring, drilling, etc. This manual only provides general installation and operation instructions. If you have
any reservations about your installation skills, please contact your local authorized Bass Habit dealer for help.

CHOOSING AMPLIFIER MOUNTING LOCATIONS

Choose a mounting location in an area where the amplifier will not be damaged, and where the amplifier is
not covered up. Mount the amplifier so that it remains dry - never mount an amplifier outside the vehicle or in
the engine compartment. Amplifier cooling is essential for proper amplifier operation. If the amplifier is to be
installed in an enclosed space, make sure there is sufficient air circulation for the amplifier to cool itself. When
mounting the amplifier under a seat, ensure that it is clear of all moving parts and does not affect the seat
functionality. Make sure that the amplifier is mounted securely using nuts and bolts or the supplied mounting
screws.
WARNING! DO NOT START the amplifier WITHOUT a load on the speaker output terminals.
Ignoring to do so can potentially result in a circuit failure in the start up mode sequence
and leave the amplifier stuck in protect mode (see specifications for correct impedance).

INSTALLATION PRECAUTIONS

NOTE! Proceed only if you are a qualified installer, otherwise let your dealer do it.
• Always wear protective eyewear when using tools.
• Turn off all stereo and other electrical devices before you begin.
• Disconnect the (-) negative lead from your vehicle's battery.
• Keep the amplifier in the package until final installation, and always rest it upwards.
• Never use force when installing a amplifier.
• Locate all fuel lines, brake lines, oil lines and electrical cables when planning your installation.
• Check clearances on both sides of a planned mounting surface before drilling any holes or fixing screws.
• When routing cables, keep input-signal cables away from power cables and speaker wires.
• When making connections, make certain all cables are secure and properly insulated.

STEP 1) POWER CONNECTIONS

The Bass Habit SPL Elite amplifiers are capable of delivering extremely high power levels and require a
heavy-duty and reliable connection to the vehicle's electrical system. To get the very best performance out
of your Bass Habit SPL Elite amplifier, carefully follow the instructions below:
GROUND CONNECTION (GND):
Connect the amplifiers Ground (GND) terminal to a solid point on the vehicles metal chassis, as close to the
amplifiers as possible. Scrape away any paint from this location; use a star-type lock washer to secure the
connection.
Ground wire recommended size:
SE550.2DF: 4 awg/ 20mm2
SE225.4DF: 4 awg/ 20mm2
POWER CONNECTION (+12V):
Connect a wire directly to the vehicles positive battery terminal, and install an appropriate fuse and holder
within 30cm/12" from the battery terminal. Keep the fuse uninstalled at the time for routing and connecting the
power wire. Be sure to use grommets whenever routing wires through the firewall or other metal parts. When
routing/connecting is done, installation of the fuse into fuse holder can be finalised.
+12V wire recommended size:
SE550.2DF: 4 awg/ 20mm2
SE225.4DF: 4 awg/ 20mm2
SE550.4DF: 2 awg/ 35mm2
SE2200.5DF: 2 awg/ 35mm2
SE550.4DF: 2 awg/ 35mm2
SE2200.5DF: 2 awg/ 35mm2