Simple Network Time Protocol (Sntp) - GE MiCOM P40 Agile Technical Manual

Chapter 5 - Operation
Various SNMP client software tools can be used. GE recommends using an SNMP MIB browser, which can perform
the basic SNMP operations such as GET, GETNEXT and RESPONSE.
Note:
When communicating with the Redundant Ethernet Card, there are two IP addresses visible: one for the IED and one for the
Ethernet switch on the redundant Ethernet board. To access the network using SNMP, use the IP address of the redundant
Ethernet board switch and not that of the IED. See the Configuration chapter for further information.
4.5

SIMPLE NETWORK TIME PROTOCOL (SNTP)

Simple Network Time Protocol (SNTP) is used to synchronize the clocks of computer systems over packet-switched,
variable-latency data networks, such as IP. A jitter buffer is used to reduce the effects of variable latency
introduced by queuing, ensuring a continuous data stream over the network.
SNTP is supported by both the IED and the switch in the redundant Ethernet board. Both the IED and the
redundant Ethernet board have their own IP address. Using the IP address of each device it can be synchronised to
the SNTP server.
For the IED this is done by entering the IP address of the SNTP server into the IED using the IEC 61850 Configurator
software.
For the redundant Ethernet board, this is done depending on the redundant Ethernet protocol being used. For PRP
or HSR, use the PRP/HSR Configurator. For RSTP use the RSTP Configurator. For SHP and DHP use Switch Manager.
74
Address
4 etherStatsOctets
5 etherStatsPkts
6 etherStatsBroadcastPkts
7 etherStatsMulticastPkts
8 etherStatsCRCAlignErrors
9 etherStatsUndersizePkts
10 etherStatsOversizePkts
11 etherStatsFragments
12 etherStatsJabbers
13 etherStatsCollisions
14 etherStatsPkts64Octets
15 etherStatsPkts65to127Octets
16 etherStatsPkts128to255Octets
17 etherStatsPkts256to511Octets
18 etherStatsPkts512to1023Octets
19 etherStatsPkts1024to1518Octets
20 etherStatsOwner
21 etherStatsStatus
Name
Px4x-REB-TM-EN-6