Prp/Hsr Configurator; Connecting The Ied To A Pc; Installing The Configurator; Starting The Configurator - GE MiCOM P40 Agile Technical Manual

4

PRP/HSR CONFIGURATOR

The PRP/HSR Configurator tool is intended for MiCOM Px4x IEDs with redundant Ethernet using PRP (Parallel
Redundancy Protocol), or HSR (High-availability Seamless Redundancy). This tool is used to identify IEDs, switch
between PRP and HSR or configure their parameters, configure the redundancy IP address, or configure the SNTP
IP address.
4.1

CONNECTING THE IED TO A PC

Connect the IED to the PC on which the Configurator tool is used. This connection is done through an Ethernet
switch or through a media converter.
TXA
RXA TXA
V01806
Figure 4: Connection using (a) an Ethernet switch and (b) a media converter
4.2

INSTALLING THE CONFIGURATOR

To install the configurator:
1. Double click the Configurator installer.
2. Click Next and follow the on-screen instructions.
4.3

STARTING THE CONFIGURATOR

To start the configurator:
1. Select the Configurator from the Windows Programs menu.
2. The Login screen appears. For user mode login, enter the Login name as User and click OK with no
password.
Px4x-REB-TM-EN-6
Ethernet switch
RXA TXB RXB
RXB TXB
IED
(a)
Chapter 4 - Configuration
RJ45
Media
Converter
TX RX
RXA TXA RXB TXB
IED
(b)
43