Raider RD-EBC02 User Manual page 16

16 www.raider.bg
6.2. Sharpening or replacement of the cutting edge.
Replace dull or damaged blades. Blade is removed by bolt unscrewed the main center of the knife
with a wrench 36. Before inserting a new blade or after you have banished the old one, make sure
the blade is positioned correctly and both pins are put into holes in the knife. Beware! One pin is
irregularly cylindrical shape and can only come into the corresponding hole of the knife. This ensures
the installation of the only knife in the correct position. Then tighten the bolt again and make sure that
no gaps and the knife is installed correctly. Use only suitable for hair cutters.
6.3. Always clean the main hair when I leave for longer storage. Especially in winter. Grease a knife
with oil to protect it from rust. To save space, you can disassemble the top of the hair on the bottom.
7. Faults and correct them.
The table below shows symptoms of failure and how you can help if your hair is no longer working
properly. If you can not find and fix the problem by following the instructions in the table, contact an
authorized service Ryder. Warning: before removal of damaged hair and stop it off from the mains.
Faults
Mower does not
start to work
The engine is on,
but the knife does
not rotate.
Engine is turned
off suddenly.
Unusual noise.
Strong vibrations.
Unequal mowing.
Engine work
hard and reduce
turnovers.
If necessary, repair your mower is best carried out only by qualified experts in workshops on
RAIDER, which used only original spare parts. Thus ensuring their safe operation.
8. Information on noise and vibration emitted.
The values are defined by Directive 2000/14/ES (1,60 m height and spacing 1,0 m). A level of noise
generated by the machine is usually the sound pressure level LpA = 82 dB. Guaranteed sound power
Removal
Power cable is not connected or
damaged
Mower is in a tall grass.
It is possible that the mower is fuzzy
and the blade is blocked.
Plug is withdrawn
Bolt is loose or the blade connections
between fasteners.
Distorted and damaged knife.
The grass is very high.
The knife is blunt.
It is possible that the mower is fuzzy
and blocked
The sword can be installed incorrectly. . Check. See 5.2
Reasons
Check cable. If necessary, replace
it.
Upon initial release always put the
mower in the grass
Disconnect the plug and check it.
Put on your protective gloves and
clean the knife and release
Check cable. Make sure it is well
enshrined in prispoblenieto (16)
and plug it again.
Fasten the parts.
Immediately stop the mower and
replace the knife in a specialized
service.
Increase mowing height.
Replace or tipped knife. See 5.2.
Look underneath the mower
and clean it. Work always with
protective gloves.