Raider RD-EBC02 User Manual page 15

4. Starting the engine.
4.1. Plug the extension cord to plug. Then plug the other end of the bridge contact 230 V. Make sure
the cord is away from the mower blade and the area to begin to mow.
4.2. Turn on the electric hair grass by pressing a button the seat and press the lever of the switch
to the handle. Release the safety button.
4.3. Electric hair grass off by running the lever of the switch and you wait for the knife to stop
spinning!
Do not switch the mower immediately after taking it off.
5. Practical tips:
5.1. Observe local regulations for the time of day during which you can use the machine outdoors.
In some countries it is forbidden mowing in the morning before 08.00 hours, after lunch between 2:00
p.m. to 16:00 hours and after 22:00 at night to protect citizens from unwanted noise.
5.2. Often lawns are composed of different varieties of grasses. If you frequent mowing will enhance
the growth of these varieties form dense turf and strong roots. If you mow your lawn frequently will
strengthen and improve the development of high-growing grasses and weeds. The normal height of
the grass is about 4-5 cm. It is also to plan the frequency of mowing, with a cut to reduce at most one
third of the total height of grass. Do not mow the grass at lower than 4 cm, because eventually it will
be drought damage.
5.3. Mow the lowest height (28 mm) only if your lawn area is very flat, expect heavy rains or will
leave.
5.4. The average height of cut (43 mm) is best when the interval between the previous and next
mowing are not lengthy.
5.5. Cutting height of (58 mm) is suitable for the first mowing of the season and when there is
drought.
5.6. When working in very difficult conditions to be careful not overload the motor. Overload the
speed of the motor falls and its sound is changing. In this case, stop, release the lever to include
(1) and set at a height of mowing. Otherwise, productivity will be reduced and the machine may be
damaged.
5.7. When mowing close to edges, careful not to pinch the hair with foreign objects.
5.8. Cutting performance depends on the density, humidity, grass length and the height of cut.
Cutting performance decreases with frequent switching of the hair during cutting. To optimize the
performance of mowing recommended more frequent mowing, increasing the height of cut and work
with moderate speed.
6. Service, maintenance and storage.
WARNING! Always disconnect the plug from the wall outlet before making activities related to
maintenance or cleaning!
Once the machine is off, the blade continues to rotate for a while coasting! Before you start working
on your hair, wait for the rotation of the motor and the blade to stop completely!
Never try to stop the rotation of the knife!
When you need to operate in proximity to the knife, work gloves always!
Perform maintenance procedures regularly to ensure durable and reliable use of the hair. Check it
periodically for visible defects such as loose or damaged knife and loose screw connections. Make
sure lids and protective equipment are intact and are installed correctly.
6.1. Cleaning.
Easiest to clean your hair immediately after mowing. After working carefully clean the machine with
a soft brush and cloth. Do not use water and / or solvents and detergents. Remove any bits of grass,
especially from the vents. Place the machine on its side and clean the blade area. Work Always wear
gloves! Remove particles stuck firmly to wood or plastic block.
15