Table of Contents
Advertisement
8
Separate the face of the new thermostat from the wall plate.
Apply pressure at two tabs on top of wall plate to release it.
NOTE: It is not recommended that this Z-wave
thermostat be mounted onto metal structures.
Metal may adversely affect the radio frequency (RF)
communication between the thermostat and the
Z-wave
bridge.
TM
9
Mark two mounting holes using new wall plate.
a.
Pull wires through hole in center of wall plate.
b.
Locate the new wall plate over existing opening.
c.
Mark two holes with pencil.
d.
Use a level to verify that the two hole locations are level.
e.
Correct hole locations as needed.
10
Prepare two mounting holes.
a.
Drill 1/16" pilot holes in the two locations that were marked in step 9.
If mounting to drywall with no studs behind it, enlarge pilot holes to
1/8" for anchors (included with the thermostat).
b.
If using anchors, screw them into the holes.
11
Install new wall plate.
a.
Pull wires through hole in center of wall plate.
b.
Locate the new wall plate over existing opening.
c.
Attach wall plate to wall using two screws provided. Do not overtighten.
TM
Tabs
Wall plate
Anchors
5
Advertisement
Table of Contents
