Table of Contents
Advertisement
24
Establish Online Control of the Thermostat.
Schlage LiNK account must be active before continuing. See link.schlage.com for more information.
a.
Remove the battery from the bridge.
b.
Plug the Ethernet and power cord back into the bridge.
c.
Log into your account at
d.
Click the
Climate tab and follow the onscreen instructions.
Exclusion
1.
Install a new, high-quality 9-volt battery into the bridge.
2.
Hold the bridge (1.8 meters) of the thermostat throughout the entire exclusion process.
Î
Note: After you begin the exclusion process, you have 30 seconds to complete the remainder of the steps.
Study the steps below before beginning.
3.
Press and release the minus (-) button on the bridge.
4.
Press the
MENU
5.
Scroll down to
6.
Press the
Yes
button to exclude the thermostat.
7.
Observe the lights on the bridge. The orange light will blink while exclusion is taking place. Exclusion is complete when
the orange light becomes solid.
NOTE: Z-Wave™ controllers from various manufacturers may support the Z-Wave™ Thermostat General V2
Device class used by the Trane Z-Wave™ Thermostat.
consult the instructions that came with the controller to find out how to enroll a new device.
www.schlagelink.com
button on the thermostat.
Z-Wave Install
and press the
Select
button.
If you are using a controller that is not a Schlage bridge,
16
Advertisement
Table of Contents
