Setup; Unfolding The Handle; Checking The Oil Level; Product Overview - Toro 23515 Operator's Manual

Setup

Unfolding the Handle

1. Remove the cable tie securing the upper arm to
the upper handle.
2. Rotate the handle to the operating position.
Note:
Make sure that the transport latch pin is
in the locked position
1. Transport latch
pin—Unlocked position
2. Push into the lower arm.
3. Slide the oval locking rings down each side of
the upper handle over the lower handle, locking
the handle sections together.

Checking the Oil Level

Check the engine oil level; refer to
Engine-Oil Level (page
(Figure 4).
Figure 4
3. Rotate the latch pin over
the handle.
4. Transport latch
pin—Locked position
Checking the
24).

Product Overview

1. Tine-control lever
2. Taction-control handle
3. Handlebar

Controls

g030543
Tine-Control Lever
The tine-control lever lifts and lowers the rear wheels.
Push down the tine-control lever to lift the wheels,
transferring the weight of the machine onto the tines.
Pull up the lever to lower the wheels and raise the
tines (Figure 6).
Note:
If you added extra optional weights to the
machine, raising the tines may require significant
effort.
Note:
Make sure that the transport-lock pin is
engaged when transporting the machine (see
4).
9
Figure 5
4. Fuel tank
5. Recoil starter
g030585
Figure