Changing The Oil Filter - Toro 23515 Operator's Manual

1. Oil-drain plug
6. Tip the machine upright again, clean the oil from
the frame with a rag.
7. Install the drain plug, and tighten it to 6.9 N∙m
(61 in-lb).
Adding Oil to the Engine
1. Slowly pour the specified oil into the oil fill
tube, periodically checking the level with the
dipstick, until the oil level is at the full mark;
refer to Engine Oil Specification (page
Engine Oil Capacity (page
the Engine-Oil Level (page
Important:
Do not overfill the engine with
oil. If you overfill the engine, pour some oil
out of it.
2. Insert the dipstick into the filler neck, and tighten
the dipstick cap.

Changing the Oil Filter

Removing the Oil Filter
Service Interval: Every 100 hours
1. Drain the engine oil; refer to
Oil (page 24).
2. Place a rag under the oil filter
catch oil when you remove the filter.
3. Remove the filter from the oil-filter adapter
(Figure 33).
Figure 32
2. Drain port
24), and Checking
24).
Draining the Engine
(Figure
g372562
1. Oil-filter adapter
4. Wipe clean the mounting surface of the filter
adapter.
Installing the Oil Filter
1. Apply a coat of the specified oil onto the gasket
24),
of the new oil filter
Oil Specification (page
1. Gasket (oil filter)
2. Thread the filter onto the oil-filter adapter until
32) to
the gasket is flush to the adapter, then hand
tighten the filter another 2/3 turn.
25
Figure 33
2. Oil filter
(Figure 34); refer to
24).
Figure 34
g372583
Engine
g002805