Tine Maintenance; Checking/Replacing Tines - Toro 23515 Operator's Manual

Tine Maintenance

Checking/Replacing Tines

Service Interval: Before each use or daily
Preparing to Service the Tines
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. Ensure that the tines are raised.
3. Remove the tine-access panel; refer to
Removing the Tine Access Cover (page
4. Raise the front of the machine; refer to
the Front of the Machine (page
5. Move the bypass lever toward the shaft-support
bracket, and secure the lever to the bracket
(Figure 70).
Figure 70
1. Transaxle bypass handle
(disengaged position)
6. Lower the front of the machine.
21).
21).
Raising
21).
g373426
2. Shaft-support bracket
Checking the Tines
1. At the tine-access panel opening, inspecting the
tines for wear or damage
2. If the tine is worn or damaged, replace it; refer
to Replacing a Tine (page
3. Mark one of the tines with a piece of tape.
4. Manually rotate the tine assembly.
5. Repeat steps
been inspected.
6. Lift the front of the machine, release the bypass
lever from the shaft-support bracket
and lower the machine.
Note:
The bypass lever is spring-loaded to the
transaxle-engaged position.
1. Transaxle bypass handle (engaged position)
7. Install the tine access cover; refer to
the Tine Access Cover (page
Replacing a Tine
1. Remove the flange-locknut and bolt securing
the tine to the tine spider, and remove the tine
(Figure 73).
39
(Figure 71).
Figure 71
39).
1 through 4 until all the tines have
(Figure
Figure 72
21).
g373425
72),
g373427
Installing