Toro 23515 Operator's Manual page 38

Torquing the Transaxle Hardware
and Tensioning the Belt and
Chains
1. Ensure that the front axle sprocket is aligned
with the transaxle sprocket.
2. Torque the 3 flange locknuts (5/16 inch) and 4
carriage bolts as shown in
Figure 68
3. Torque the 4 flange locknuts (3/8 inch) and 4
carriage bolts as shown in
4. Tension the belt; refer to
(page 31).
5. Tension the tine-drive chains; refer to
Tine-Drive Chain Tension (page
Installing the Traction-Control
Cable
1. Align the fitting of the traction control cable
through the hole in the transaxle-control bracket
(Figure 69).
Figure 68.
g373004
Figure 68.
Adjusting Belt Tension
Adjusting
30).
1. Fitting (traction-control
cable)
2. Transaxle-control bracket
2. Secure the fitting to the bracket with the locknut.
Checking the Traction-Control
Handle
1. Carefully remove the jack stand, lower the
machine to the ground, and separate the
machine from the overhead hoist.
2. Extend the handlebar; refer to
Handlebar (page
3. Check the gap between the traction-control
handle and the handlebar; refer to
Traction-Control Handle Adjustment (page
38
Figure 69
3. Locknut (1/4 inch)
Extending the
17).
Checking the
g372913
31).