Table of Contents
Advertisement
The transmission-oil maintenance reminder
resets to 250 (hours), exits the service
transmission screen, and returns to the default
screen.
Note:
You can exit the service transmission screen
at any time by turning the key to either the OFF or
the START positions.
Tine Maintenance
Checking the Tines
Service Interval: Before each use or daily
1.
Shut off the engine, engage the parking brake,
remove the key, and wait for all moving parts to
stop before leaving the operating position.
2.
Raise the machine and support it with jack
stands with a 460 kg (1,015 lb) capacity.
CAUTION
Raising the machine for service
or maintenance relying solely on
mechanical or hydraulic jacks could be
dangerous. The mechanical or hydraulic
jacks may not be enough support or may
malfunction allowing the machine to fall,
which could cause injury.
Do not rely solely on mechanical
or hydraulic jacks for support. Use
adequate jack stands or equivalent
support.
3.
Remove the 2 thumbscrews (3/8 x 1 inch) and
2 washers (3/8 inch) that secure the rear-cover
panel to the chassis, and remove the panel
(Figure
59).
1. Chassis hole
2. Rear panel
4.
Remove rocks and other debris from the tines.
5.
Inspect the tines for wear and damage.
Note:
Replace any tines that are worn or
damaged.
6.
Align the holes in the rear-cover panel to the
holes in the chassis
48
Figure 59
3. Washer (3/8 inch)
4. Thumbscrew (3/8 x 1 inch)
(Figure
59).
g249698
Advertisement
Table of Contents
