Paradyne COMSPHERE 3825Plus User Manual page 38

\K n
Buffer Control, Send Break Control, Break Forces Escape
The \K n command sets three configuration options simultaneously:
Break
Buffer
Control
\K0 Discard Data
\K1 Discard Data
\K2 Keep Data
\K3 Keep Data
\K4 Keep Data
\K5 Keep Data
\K6 Discard Break
BREAK BUFFER CONTROL
Determines if data stored in the modem's buffer is saved or discarded when the DTE issues a break sequence.
SEND BREAK CONTROL
Determines what is sent from the modem first, data or break if a break sequence is sent from the DTE.
BREAK FORCES ESCAPE
Determines whether or not the modem should enter Command mode when it receives a break character from the DTE.
\N n Error Control Mode
Determines the type of error control used by the modem. In most cases, V42/MNPorBfr is the best choice. If V.42bis and
MNP are enabled, then the modem uses the following priority for error control negotiation: V.42bis, V.42, MNP 5 and
below. Online changes do not take effect until a disconnect occurs.
\ N0 Buffer Mode.
\ N1 Direct Mode.
\ N2 MNP or Disconnect.
\ N3 MNP or Buffer.
\ N4 V.42/MNP or Disconnect.
\ N5 V.42/MNP or Buffer.
\N6 LAPM or Disconnect.
\N7 LAPM or Buffer.
&F5 and &F6 (Cellular) set this to \N4.
The \Q n command controls two configuration options simultaneously:
\Q0
\Q1
\Q2
\Q3
\Q4
\Q5
\Q6
FLOW CONTROL OF DTE
Determines how the modem controls the flow of data from the DTE.
FLOW CONTROL OF MODEM
Determines how the DTE controls the flow of data from the modem.
3825-A2-GB30-20
Table 4-1
(13 of 14)
3825 Plus AT Commands
Send Break
Break Forces
Control Escape
Break First Enable
Break First Disable
Break First Enable
Break First Disable
Data First Enable
Data First Disable
Not Applicable Disable
Flow Control Flow Control
of DTE of Modem
Disable Disable
XON/XOFF XON/XOFF
CTS to DTE Disable
CTS to DTE RTS to Modem
XON/XOFF Disable
Disable XON/XOFF
Disable RTS to Modem
November 1996
AT Commands and S-Registers
4-15