Overspeed - Bruno ELAN SRE-3050 Installation Manual

TROUBLESHOOTING
OVERSPEED
access cap
right-hand
safety panel
Fig. 1
not tripped
SRE-3050 INSTALLATION 15mar2021
Fig. 2
The overspeed is a safety device designed
to prevent operation of stairlift if descending
travel speed becomes excessive.
Reset Overspeed Switch
When overspeed switch is tripped, wheel will not
be in the center of notch (valley).
You must reset the overspeed switch to
allow unit to operate.
1.
51
Remove right-hand safety panel.
Loosen two (2) Phillips head screws (in
red circles) in order to slide panel away
from carriage.
Remove access cap from motor side (Fig. 1).
Rotate overspeed cover until it looks
like Fig. 2.
If overspeed cover does not rotate, use
a %" socket tool or manual back up tool
available in kit SRV-3000-002 (available
from Bruno), to turn motor shaft extension
and move carriage upwards:
e turn clockwise for a left-hand
installation
e turn counterclockwise for a
right-hand installation
Check for damage to drive system.
If drive system is not damaged, use
UP / DOWN paddle control to drive
carriage off the rail for a more complete
inspection.
©Bruno Independent Living Aids, Inc.®