Parent Unit - Philips AVENT SCD525 Manual

3 Reattach the lid. (Fig. 5)

Parent unit

Operation on rechargeable batteries
The parent unit comes with two rechargeable NiMH AAA 850mAh batteries.
parent unit starts indicating that the batteries are low 30 minutes before the batteries are
completely empty.
Note: If the batteries are completely empty, the parent unit automatically switches off and loses contact
with the baby unit.
1 Remove the lid of the compartment for the rechargeable batteries (Fig. 6).
2 Insert the rechargeable batteries (Fig. 7).
Note: Make sure the + and - poles of the batteries point in the right direction.
3 Reattach the lid (Fig. 8).
4 Insert the small appliance plug into the charger, put the adapter in a wall socket and place the
parent unit in the charger (Fig. 9).
, The charging light on the charger goes on.
The display shows a charging battery symbol to indicate that the parent unit is charging.
,
5 Leave the parent unit in the charger until the batteries are fully charged.
, During charging, the charging light on the charger stays on.
When the batteries are fully charged, the display of the parent unit shows a full battery
,
symbol T.
-
off and let it charge continuously for at least 10 hours.
- Charging normally takes 8 hours, but it takes longer when the parent unit is switched on while
charging. To keep the charging time as short as possible, switch off the parent unit during
charging.
- When the batteries are fully charged, the parent unit can be used cordlessly for up to 24 hours.
batteries only reach their full capacity after you have charged and discharged them four times.
Note: When the parent unit is not in the charger, the batteries gradually discharge, even when the parent
unit is switched off.
1 Place the parent unit and the baby unit in the same room to test the connection (Fig. 10).
Make sure the baby unit is at least 1 metre/3.5 feet away from the parent unit.
2 Press and hold the on/off button 3 on the baby unit until the green power-on light goes
on. (Fig. 11)
,
The battery light T
,
3 Press and hold the on/off button 3 on the parent unit until the sound level lights light up
The display goes on and the battery symbol appears on the display (Fig. 14).
,
ENGLISH
9