EngliSh iMPORTAnT SAFETY inSTRUCTiOnS Some of the following information may not apply to your particular product; however, when using baby monitor equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: Read these instructions.
EngliSh 20 Never push objects of any kind into this product through casing slots as they may touch dangerous voltage points or short out parts that could result in a risk of fire or electric shock. Never spill liquid of any kind on the product.
EngliSh SAVE ThESE inSTRUCTiOnS CAUTiOn:ThE SYMBOl ShOWn in FigURE 1 MEAnS ThAT ThERE iS A RiSK OF EXPlOSiOn OF ThE BATTERiES AnD/OR OF SERiOUS DAMAgE TO ThE BABY MOniTOR iF ThE BATTERiES OR ThE ADAPTER ARE REPlACED WiTh An inCORRECT TYPE. Adapter for baby unit: Input: 120 VAC 60 Hz Output: 7.5 VDC 400 mA...
Congratulations on your purchase and welcome to Philips AVENT! To fully benefit from the support that Philips offers, register your product at www. philips.com/welcome. Philips AVENT is dedicated to producing caring, reliable products that give parents the reassurance they need. This Philips AVENT baby monitor provides round-the-clock support by ensuring you can always hear your baby clearly without any distracting noise.
EngliSh B Baby unit On/off button 3 PAGE button Nightlight button Q Volume +/– buttons Power-on light Battery light T Microphone Loudspeaker Adapter 10 Large appliance plug 11 Socket for large appliance plug 12 Non-rechargeable batteries (not included) 13 Compartment for non-rechargeable batteries 14 Lid of compartment for non-rechargeable batteries important Read the user manual carefully before you use the appliance and save...
Battery operation (non-rechargeable batteries) The baby unit runs on four 1.5V R6 AA batteries (not included). We recommend you to use Philips LR6 PowerLife batteries or an equivalent type. Do not use rechargeable batteries, as the baby unit does not have a charging function.
EngliSh Remove the lid of the compartment for the rechargeable battery pack. Insert the rechargeable battery pack. Note: Make sure the + and - poles of the battery pack point in the right direction. Reattach the lid. Put the small appliance plug in the parent unit and put the adapter in a wall socket.
EngliSh Using the appliance Place the parent unit and the baby unit in the same room to test the connection. Make sure the baby unit is at least 3 feet/1 meter away from the parent unit. Press and hold the on/off button 3 on the baby unit until the green power-on light goes on.
EngliSh The LINK light on the parent unit turns green and lights up continuously when a connection has been established between the baby unit and parent unit. If no connection is established, the LINK light on the parent unit stops flashing and lights up red. The parent unit beeps from time to time.
EngliSh Dry materials Material thickness Loss of range Metal or aluminum sheets < 1cm/0.4in 100% For wet and moist materials, the range loss may be up to 100%. Features Adjusting loudspeaker volume Press the volume + or - button on the baby unit until the desired loudspeaker volume for the baby unit has been reached.
EngliSh nightlight Press the nightlight button Q on the baby unit to switch on the nightlight. Press the nightlight button Q again to switch off the nightlight. The nightlight dims gradually before it goes out completely. Tip: Switch off the nightlight when you operate the baby unit on the non- rechargeable batteries.
EngliSh Reset function This function allows you to reset the parent unit and the baby unit to the default settings. You can use this function if problems occur that you cannot solve by following the suggestions in chapter ‘Frequently asked questions’.
Batteries Only replace the non-rechargeable batteries of the baby unit with four 1.5V R6 AA batteries. Note: We recommend you to use Philips LR6 powerLife batteries or an equivalent type. Adapter Only replace the adapter of the baby unit with an adapter of the original type.
FUll TWO-YEAR WARRAnTY Philips Electronics North America Corporation (USA) and Philips Electronics Ltd (CANADA) warrant each new Philips AVENT product, model SCD510/00, against defects in materials or workmanship for a period of two years from the date of purchase, and agrees to repair or replace any defective product without charge.
EngliSh Question Answer Why does the LINK light on The baby unit and the parent unit are out of range of each other. Move the parent unit flash red? the parent unit closer to the baby unit. The baby unit may be switched off. Switch on the baby unit. Why does the battery light The non-rechargeable batteries of the baby unit are running low.
EngliSh Question Answer Why does the charging time The parent unit may be switched on during charging. Switch off the of the parent unit exceed 8 parent unit during charging. hours? The specified operating range The specified range is only valid outdoors in open air. Inside your house, of the baby monitor is 330 the operating range is limited by the number and type of walls and/or meters/1000 feet.
In US manufactured for Philips Consumer Lifestyle, a division of Philips Electronics North America Corporation. 1600 Summer Street, 5 Fl., Stamford, CT 0605-515 In Canada imported for Philips Electronics Ltd, 281 Hillmount Road, Markham, ON L6C2S3 Call TOLL-FREE 1.00.5.AVENT En EE.UU. fabricado para Philips Consumer Lifestyle, una división de Philips Electronics North America...