Default Settings; Connecting The Belt Clip; Disconnecting The Belt Clip; Cleaning And Maintenance - Philips AVENT SCD525 Manual

ENGLISH
16
5
The parent unit switches off and then switches on again.
,
The units have now both been reset to the default factory settings.
,

Default settings

Parent unit
- Language: English
- Loudspeaker volume: 1
- Microphone sensitivity: 5
- Sound alert: off
- Temperature alert: off
- 'Temperature low' alert: 14°C
- 'Temperature high' alert: 35°C
- Temperature scale: Celsius
- ECO mode: off
Baby unit
- Loudspeaker volume: 3
- Nightlight: off
- Lullaby: off
outside the house if you attach the unit to your belt or waistband with the belt clip or if you hang it
around your neck with the neck strap. This allows you to monitor your baby while you are moving
around.

Connecting the belt clip

1

Disconnecting the belt clip

1 Pull the belt clip off the parent unit.
1 Insert the end loop of the neck strap through the hole behind the strap post. Thread the
neck strap through the end loop and pull the neck strap tight (Fig. 34).
1 Pass the neck strap though the end loop and pull the end loop out of the hole behind the
strap post.

Cleaning and maintenance

Do not immerse the parent unit and the baby unit in water and do not clean them under the tap.
1 Unplug the baby unit if it is connected to the mains and take the parent unit out of the
charger.
2
Make sure the parent unit is dry before you put it back into the plugged-in charger.
3