Pre-Measurement Procedures; Before Switching On The Power; Installation And Usage Environment - A&D Omniace RA3100 Instruction Manual

2.

Pre-Measurement Procedures

2.1.

Before Switching On the Power

The preparations for using this product and the cautions are explained below.
2.1.1.

Installation and Usage Environment

Use this product on a flat, level surface.
When using the printer, install it so that the recording
paper is level as indicated in the figure on the right.
Cautions Regarding the Installation Environment
Use this product at locations that satisfy the installation requirement, the Category II (CAT II) of the
safety standard for electrical measurement instruments in EN61010-1.
This product has a Pollution Degree of 2.
Use this product in the following operating environments.
Operating temperature range: 0 to 40°C
condensation)
Do not use this product at the following locations. In addition, carefully check the environment when
using this product.
Locations where the temperature and humidity rise due to direct sunlight or heaters
Wet locations
Locations where salt, oil, or corrosive gases exist
Dusty locations
Locations subject to strong vibrations
Locations with a strong electromagnetic field
This product is provided with ventilation openings in order to prevent overheating.
Ensure that the ventilation openings remain unobstructed by covers or materials. Otherwise, the
internal temperature of the product rises, causing malfunctions.
Do not place highly combustible objects such as paper near the product.
1WMPD4004444B
2.Pre-Measurement Procedures – 2.1.Before Switching On the Power
CAUTION
Operating humidity range: 35 to 85% RH (without
Exhaust
Intake
Intake
25