Barco IEX Series Product Manual page 12

• Do not direct the air outlet of an air conditioner to the LED display.
• Do not place or use the LED display in an environment with volatile, corrosive or
flammable chemical products.
• Using the LED product in an environment with high corrosive gasses (e.g. Sulphur)
can lead to discoloration of the materials. This discoloration gives a change in
brightness of the product. This could lead to uniformity differences and possibly also
to failures. Each use of the product in this kind of environment needs to be checked
up-front with the supplier.
• IEX tiles are to be used in environments meeting the operating specifications.
• IEX tiles are not to be used in environments that are subject to airborne contaminants
such as that produced by smoke machines (cracked oil) or similar (these deposit a thin
layer of greasy residue upon the LEDs optics, degrading performance).
• IEX tiles are not to be exposed to extreme localized heat or cold exceeding the
temperature specifications.
• IEX tiles are not to be exposed to any element or situation that will cause any part
of the display to heat beyond what occurs during normal operation. Such situations
include but are not limited to lasers, ultrasonic vibration, or any type of substance that
prevents proper ventilation and heat radiation of the IEX tiles.
• IEX tiles are not to be exposed to circumstances where moisture can condense or
collect on any components.
• Power connected to the IEX tiles must meet the specifications outlined in the
installation manual.
• Avoid any accidental bumping of the module corners while installing or removing the
IEX module. Since LED's of the IEX modules are mounted near by the edges of the LED
boards, which is unavoidable in the design of a high resolution LED-wall, the corners
of the IEX modules become sensitive for mechanical damage. Because of that it is
required to handle the IEX modules with care at all times.
• Never place an IEX module upon a surface with the LED's facing downwards without
protection. This to prevent damage to the LEDs and the soft lens of the LEDs.
• While removing or installing the IEX modules always keep the LED side of the IEX
module parallel with the LED side of the remaining neighboring IEX modules. This to
avoid any mechanical stress upon the corners of the IEX modules.
R5915190 /00 IEX
11 IEX SERIES