Remove And Insert Battery - decon Flexlife D9 User Manual

•
It is forbidden to use the battery in too hot or cold environment (outside the recommended
temperature zone).
•
When the new battery packs are used for the first time, they must be fully charged (approximately
24 hours).
•
Before daily use, the user should check if the charging is sufficient or not, charge in time.
•
After the first time, the charging should be about 5 hours. When the battery is completely exhausted,
the charging time should be 6 to 8 hours, until the light on the charger changes from red to green.
•
Charge the battery frequently as long as the electric wheelchair is used. Charge the battery after use
until it is full. If you don't use your Flexlife for a long time, recharge the batteries every two months,
each time to about 80%. It will damage the battery if it does not get charged for a long time.
•
Using batteries with the wrong specification, voltage or capacity will damage your Flexlife.

REMOVE AND INSERT BATTERY

Make sure the power is turned off before performing this action.
Remove the battery:
•
Press the lock button (as shown in Fig. 1),
•
Then pull the battery handle (as shown in Fig. 2).
•
Pull the battery out of the battery tube.
Fig 1
Flexlife User Manual D9 - ENG
2020-03
Revision 2
fig 2 fig 3
29