Table of Contents
Advertisement
s
i
afety
nstrUctions
Please read the entire instruction manual before operating the Dry Block Heater.
WARNING! DO NOT use the Mini Block Heater in a hazardous atmosphere
or with hazardous materials for which the unit was not designed. Also, the
user should be aware that the protection provided by the equipment may
be impaired if used with accessories not provided or recommended by the
manufacturer, or used in a manner not specified by the manufacturer.
Always operate unit on a level surface for best performance and
maximum safety.
CAUTION! To avoid electrical shock, completely cut off power to the unit
by disconnecting the power cord from the unit or unplug from the wall outlet.
Disconnect unit from the power supply prior to maintenance and servicing.
Spills should be removed promptly, after the unit has cooled down. DO NOT
immerse the unit for cleaning. DO NOT operate the unit if it shows signs of
electrical or mechanical damage.
The main supply power cord provided with this product is rated to safely
handle the products electrical load under the stated environmental conditions.
DO NOT replace the cord with an inadequately rated main supply cord.
The Mini Block Heaters are designed to be operated in dry conditions. DO
NOT put water, oil or other fluids in the wells of the units. The chamber
that the modular heating blocks and baths sit in is not designed to be filled
with liquid or other fluids. DO NOT place anything other then the appropriate
heating block(s) in this cavity.
CAUTION! Mini Block Heaters are not explosion proof. Use caution when unit
is on or when heating volatile materials.
Earth Ground - Protective Conductor Terminal
Alternating Current
3
s
& r
tandards
egUlations
Henry Troemner, LLC hereby declares under its sole responsibility that the
construction of this product conforms in accordance with the following standards:
Safety standards:
Safety requirements for electrical equipment for measurement, control and laboratory use:
EN 61010-1
UL 61010-1
CAN/CSA C22.2 No. 61010-1
EN 61010-2-010
CAN/CSA C22.2 No. 61010-2-010
EMC standards:
IEC 61326-1 / EN 61326-1
Associated EU guidelines:
2014/30/EU
2014/35/EU
2011/65/EU
Part I: General requirements
Part II: Particular requirements for laboratory
equipment for the heating of materials
Electromagnetic compatibility (EMC)
requirements for electrical equipment for
measurement, control and laboratory use
The Electromagnetic Compatibility Directive
The Low Voltage Directive
The Restriction of Hazardous Substances Directive
Advertisement
Table of Contents
