Table of Contents
Advertisement
Item
Description
Powered pairs
HW: Class
Watts at PD
Volt minimum
Volts under load
SW Negotiated
Class:
Watts at PD
Table 14. PoE Test Results (cont.)
Shows which pairs have power.
The hardware negotiated power class (Class 0 to Class 8) of the
PSE device.
The loaded power in watts provided by the PSE at the PD.
The minimum required volts the device needs to meet under load
per the IEEE 802.3 standard based on the HW negotiated power
class (
).
Measured voltage under load at reported power draw.
: Indicates the voltage meets the requirements for the HW
negotiated power class (
: Indicates the voltage does not meet the requirements for
the HW negotiated power class (
Or,
The switch under test cannot deliver power to the device
because the maximum power which the switch can deliver is
already in use.
The software negotiated power class (Class 1 to Class 8) of the
device.
This section does not show information, If:
The device does not support the voltage required to meet
the HW negotiated power class.
The device does not support software negotiation.
The loaded power in watts provided by the PSE at the PD.
Cable+Network Tester
Function
).
).
Switch Test Results
33
Advertisement
Table of Contents
