Fluke LinkIQ User Manual page 34

LinkIQ
Users Manual
Item
General section
IP Address
Round Trip
Times
Packets
Lost
Size
Error
information
Network
My IPv4 or
My IPv6
Subnet Mask
DHCP Server
Offer Time
30
Table 13. Ping Test Results
The IP address configured in Settings > Ping,
The round trip time in ms from each time the Product pings the IP address.
shows if no packets are lost.
shows if one or more packets is lost.
The number of lost packets. For example 1/4 indicates one packet is lost
of the four packets sent.
The size in bytes (typically 64 bytes) of the ping packet sent for each test.
If one or more packets is lost, an error message shows with a description
of the problem of the first lost packet.
The information that shows depends on the configuration of the network.
If the Product detects only one protocol (IPv4 or IPv6) on a network, the
information for that protocol shows. If the Product detects both protocols,
the information for both protocols shows.
Information for the DHCPv6 server shows only if the network uses
DHCPv6. If the network uses SLAAC without DHCPv6, the DHCP server
address, offer, ACK, and lease times do not show.
The address the Product receives from the DHCP server as an offer or the
user-defined static address.
The subnet mask of the network the Product connects to and tests on.
The IP address of the DHCP server.
For IPv4 addresses, this is the length of time between when the Product
sends the discovery signal and receives an address offer from the DHCP
server.
For IPv6 addresses, the DHCPv6 advertised time shows. The advertised
time is the time between when the Product sends the DHCPv6 solicit
packet and receives the advertise response packet.
Description