elero VarioTec-868 DC Operating Instructions Manual

elero VarioTec-868 DC Operating Instructions Manual

Advertisement

Quick Links

VarioTec-868 DC
28 345.0006
Operating Instructions
Keep the operating instructions in a safe place!
181234001_EN_0918

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the VarioTec-868 DC and is the answer not in the manual?

Questions and answers

Summary of Contents for elero VarioTec-868 DC

  • Page 1 VarioTec-868 DC 28 345.0006 Operating Instructions Keep the operating instructions in a safe place! 181234001_EN_0918...
  • Page 2: Table Of Contents

    Connection and initial start-up Radio systems Programming Technical specifications Cleaning and maintaining the device EC declaration of conformity Troubleshooting Repair Manufacturer's address Disposal / Notes on protection of the environment Ⓒ elero GmbH EN | 3 Ⓒ elero GmbH 2 | EN...
  • Page 3: General Information

    The manufacturer reserves the right to make changes to The device may be used only as a elero ProLine or Pro- the specifications stated in these operating instructions at Line 2 radio control in conjunction with elero drive motors any time.
  • Page 4: Warranty And Liability

    The device is to be used only in technically flawless state as well as in accordance with the requirements, conscious If you have not purchased the product directly from elero, of risk and in compliance with the operating instructions. please contact the supplier of the device.
  • Page 5: Requirements For Personnel

    ‰ Any personnel who have been assigned to work with the device must not have any physical restrictions that tem- The VarioTec-868 DC is not only an easy-to-use radio porarily or permanently restrict he attention and judgment receiver, but also a wired controller for roller shutters and (e.g., due to fatigue).
  • Page 6: Scope Of Delivery

    ‰ Button [Pos ▼] (under the cover flap): Programming an Intermediate Position, Deleting an Intermediate Position. ‰ Button [Pos ▲] (under the cover flap): Programming a Ventilation/Turning Position, Deleting a Ventilation/Turning Position. Ⓒ elero GmbH EN | 11 Ⓒ elero GmbH 10 | EN...
  • Page 7: Connection And Initial Start-Up

    Connection and initial start-up 3.3.4 and 3.3.5). WARNING! • Risk of damage or destruction of VarioTec-868 DC or any other existing control units by faulty control. Danger to life due to faulty • Damage to the blind from incorrect running direction: electrical connection.
  • Page 8 For the connection with other control units, use a shielded control cable, 0.8 mm, or a telephone cable, JY-ST 0.6 mm, for both connection types. Emergen- Connection Application The design for an elero control unit can be found in the cy signal type elero controller catalog. Group venetian blind •...
  • Page 9 • Additional group control units and drive control units may Delete intermediate position / be connected (see „Installation instructions and wiring ventilation position diagrams“ in the download area at elero.com) Reset button flashes green Shows readiness for programming (re- Mains...
  • Page 10: Radio Systems

    ‰ Ventilation position when using roller shutters: 1. After a power interruption or if the [P] button is pressed Vents open on the VarioTec-868 DC, it is ready to programmed for 5 minutes. The LED flashes green once. ‰ Turn position when using blinds: Turns the blind slats by brief travel in the opposite direc- 2.
  • Page 11 / fabric stretching position with a programmed hand-held transmitter. You can also approach the ventilation position / turn positi- on / fabric stretching position with a programmed hand-held transmitter. Ⓒ elero GmbH EN | 21 Ⓒ elero GmbH 20 | EN...
  • Page 12: Technical Specifications

    Rated surge voltage 4 kV Article number 28 345.0006 Switching current 5 A / 250 V AC at cos φ = 1 Fig. 6 Technical Specifications VarioTec-868 DC Ⓒ elero GmbH EN | 23 Ⓒ elero GmbH 22 | EN...
  • Page 13: Cleaning And Maintaining The Device

    EC declaration of conformity Fig. 7 Troubleshooting VarioTec-868 DC Repair elero hereby declares that radio system VarioTec-868 DC is in compliance with Directive 2014/53/EU. The full text of the EU Declaration of Conformity is available at the following Please contact your dealer if you have any questions.
  • Page 14: Manufacturer's Address

    By recycling, material recycling or other forms of utilizing of old devices or batteries, you make an important contribution to protecting our environment. Ⓒ elero GmbH EN | 27 Ⓒ elero GmbH 26 | EN...
  • Page 15 Ⓒ elero GmbH 28 | EN...

This manual is also suitable for:

28 345.0006

Table of Contents