Connection and initial start-up Radio systems Programming Technical specifications Cleaning and maintaining the device EC declaration of conformity Troubleshooting Repair Manufacturer's address Disposal / Notes on protection of the environment Ⓒ elero GmbH EN | 3 Ⓒ elero GmbH 2 | EN...
VarioTec-868 (-915) (hereinafter referred to as controller for roller shutters and sun protection. "device"). The device may be used only as a elero ProLine or Pro- The manufacturer reserves the right to make changes to Line 2 radio control in conjunction with elero drive motors the specifications stated in these operating instructions at (blind systems, awnings, and roller blinds systems).
The device is to be used only in technically flawless state as well as in accordance with the requirements, conscious If you have not purchased the product directly from elero, of risk and in compliance with the operating instructions. please contact the supplier of the device.
The data communication is unidirectional or bidirectional bly, and cleaning work by minors or persons under the in- (compatible with the elero ProLine 2 product line). fluence of alcohol, drugs, or medication is not permitted. The environment for the intended use are residential and ...
On the ground (or close to the ground). The control unit of the unidirectional VarioTec-868 (-915) cannot be operated with the power supply of the bidirectio- The minimum distance to other elero radio transmitters nal VarioTec-868 (-915). or radio receivers must be 20 cm.
Page 8
• The drive is connected directly to the device • Use enclosed cable bridge according to wiring diagram Emergen- Connection Application cy signal type Group venetian blind ( "ON“) control unit Ⓒ elero GmbH EN | 15 Ⓒ elero GmbH 14 | EN...
Page 9
• Control multiple drives at the same time flashes green Program intermediate position / • Additional group control units and drive control units may three times ventilation position be connected (see examples in elero Control Catalog) Delete intermediate position / ventilation position [Reset] button Mains flashes green...
Turns the blind slats by brief travel in the opposite direc- 2. Program individual transmitters to the VarioTec-868 tion (-915) according to the transmitter instructions. Fabric stretching position when using awnings: Fabric taut Ⓒ elero GmbH EN | 19 Ⓒ elero GmbH 18 | EN...
Page 11
/ fabric stretching position with a programmed hand-held transmitter. You can also approach the ventilation position / turn positi- on / fabric stretching position with a programmed hand-held transmitter. Ⓒ elero GmbH EN | 21 Ⓒ elero GmbH 20 | EN...
5 V DC unit via power supply unit max. 0.5 A Rated surge voltage 4 kV Switching current 5 A / 250 V AC at cos φ = 1 Ⓒ elero GmbH EN | 23 Ⓒ elero GmbH 22 | EN...
Fig. 7 Troubleshooting VarioTec-868 (-915) EC declaration of conformity Repair elero hereby declares that radio system VarioTec-868 is in compliance with Directive 2014/53/EU. The full text of the Please contact your dealer if you have any questions. EU Declaration of Conformity is available at the following...
By recycling, material recycling or other forms of utilizing of old devices or batteries, you make an important contribution to protecting our environment. Ⓒ elero GmbH EN | 27 Ⓒ elero GmbH 26 | EN...