elero InDrive M30/1.6 RH Operating And Assembly Instructions Manual

InDrive M30/1.6 RH
Actuator for Louvre Roof
Contents
1 Operating and assembly instructions
2 General information on these instructions
2.1 Standards and guidelines
2.2 Intended use
2.3 Foreseeable misuse
2.4 Warranty and liability
2.5 Customer service provided by the manufacturer 2
3 Safety
3.1 General safety instructions
3.2 Layout of safety instructions
4 Product description
4.1 Product contents
4.2 Accessories
5 Assembly
5.1 Mechanical fastening
5.2 Electrical connection
5.3 Connection example: InDrive M30/1.6 RH
230 V / 50 Hz
5.4 Parallel circuit
5.5 Commissioning
5.6 Setting the end positions and release
5.6.1 Release function for end positions
5.6.2 Release function in initial position
5.6.3 Release function in end position
5.6.4 Changing/deleting end positions and deleting the
release function
5.6.5 Four end position variants
5.6.6 Variant A: Initial position and end position freely
adjustable
5.6.7 Variant B: Initial position at limit stop, end position
freely adjustable
5.6.8 Variant C: Initial position and end position at limit
stop
5.6.9 Variant D: initial position freely adjustable, end
position at limit stop
6 Troubleshooting
7 Servicing
8 Service/manufacturer's address
9 Repairs
1 10 Disassembly and disposal
1 11 Conformity Declaration
1 12 Technical data and dimensions
2 12.1 InDrive M
2
2
2
2
InDrive M30/1.6 RH Actuator
2
1

Operating and assembly instructions

3
3
Follow these instructions for safe and proper use. Observe all
assembly instructions since incorrect assembly can lead to
3
serious injuries. Keep the instructions for future reference.
The German operating instructions are the original
3
version.
4
All documents in other languages are translations of the
original version.
4
All rights reserved in the case of patent, utility model or design
registrations.
5
2

General information on these instructions

5
The content structure is based on the life cycles of the electric
5
motor drive (hereinafter referred to as "the product").
The manufacturer reserves the right to make changes to the
5
technical data in these operating instructions. In some cases,
this technical data may differ from those of the respective
5
product version; however, the functional information will not
undergo significant changes or become invalid. The current
5
version of the technical specifications may be requested from
5 the manufacturer at any time. No claims may be asserted
against the manufacturer as a result of this provision.
Deviations from textual or visual statements may occur
depending on the product's technical development, features
5
and accessories. Deviating information for special versions will
6 be provided by the manufacturer in the sales documentation.
Other information shall remain unaffected by these provisions.
2.1

Standards and guidelines

6
During construction, the fundamental health and safety
requirements were applied and provision was made for the
6 appropriate legislation, standards, directives and guidelines.
The safety of the product is confirmed by the declaration of
conformity (see Declaration of Conformity). All information
6 relating to safety in these operating instructions refers to the
laws and regulations that are currently valid in Germany. All
information in these operating instructions must be complied
7 with at all times and without limitation. In addition to the
safety notes in these operating instructions, the regulations
7
on accident prevention, environmental protection and
occupational health and safety applicable at the location
7
of use must be observed and adhered to. The regulations
and standards for safety assessment can be found in the
7
Declaration of Conformity.
7
7
8
8
8
138209401_EN_0621