Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Saxby Lighting 13929
Summary of Contents for Saxby Lighting 13929
- Page 1 Pyramid LED Post Light 13929...
- Page 2 Thank you for purchasing this light fitting. Please read the instructions carefully before use to ensure safe and satisfactory operation of this product. Please retain these instructions for future reference. Warning This is a Class 1 product and must be earthed. Please read these instructions carefully before commencing any work. This unit must be fitted by a competent and qualified electrician. Install in accordance with IEE Wiring regulations and current Building Regulations. To prevent electrocution switch off at mains supply before installing or maintaining this fitting. Ensure other persons cannot restore the electrical supply without your knowledge. If you are in any doubt, please consult a qualified electrician. This light fitting should be connected to a circuit with a 30mA RCD fitted. If replacing an existing fitting, make a careful note of the connections. This system contains non-replaceable parts and cannot be serviced. If damage occurs the part should be scrapped. Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your local authority or retailer for recycling advice. This product is not suitable for dimming. This product is rated at IP44. This product is not suitable for location in or near a marine or sea environment. The entire unit gets hot whilst on for a period of time. Specification Voltage: 240V 50Hz a.c. 76.0mm dia Lamp: 4.5W Max. 36 LED’s IP rating: 117.0mm dia Layout •...
- Page 3 Installation Existing fittings must be completely removed before installation of a new product. Before removing the existing fitting, carefully note the position of each set of wires. Using base plate as a template, mark the fixing holes onto the mounting surface. Drill holes to the necessary size and depth - taking care not to damage any concealed pipes or wiring below the mounting surface.
- Page 4 Commissioning 12. Push the terminal block up into the tube. 13. Locate the product in position and fit the screws to secure in place. 14. Replace fuse or circuit breaker and switch on. Your light is now ready for use. Fitting / Replacing Bulbs Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Care and Cleaning Do not use solvents or abrasive cleaners as these could damage the finish. In normal circumstances, stainless steel is very resistant to corrosion. It does however require maintenance to preserve the high quality appearance. Wash the product with warm soapy water, removing all surface deposits. Rinse with clear water and with a soft cloth, wipe dry. In some cases, surface corrosion may arise after installation. This is normally caused by tiny iron particles left behind after the brushing process when finishing. Wash and dry as detailed above. Then with a soft cloth soaked with a protective oil, wipe all over. However if the product is subject to extreme environmental conditions such as marine locations, industrial pollution and acid rain these maintenance procedures should be carried out around four times a year. For severe corrosion, non-abrasive cream cleaners or proprietary stainless steel cleaners should be used to remove the corrosion. Wash and dry as detailed above. Then with a soft cloth soaked with a protective oil, wipe all over. Do not clean the units with a pressure washer. Recycling Advice Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice. Safety Information For your safety, always switch off the supply before changing lightbulbs, cleaning or removing shades.
Need help?
Do you have a question about the 13929 and is the answer not in the manual?
Questions and answers