Fitting/replacing bulbs
• When changing a bulb, always switch off at the mains
and allow the bulb to cool before handling. Dispose
of used bulbs carefully. Use a soft cloth to handle
bulbs, avoid directly touching the bulbs as this will
shorten their life. Do not exceed the wattage stated or
use a different shape bulb from that indicated on the
fitting. This fitting will accept up to a maximum lamp
of 100W. This is dependant on the capacity of the
transformer. Refer to the transformer instructions.
• Switch off and allow bulb to cool before replacing.
• Remove circlip by squeezing tabs together, to release
the bulb. Pull the bulb out of the lampholder.
• Hold the old bulb and ease the spade terminals off.
Replace with bulb type AR111 only.
• Refit the spade terminals onto the back of the bulb
and refit the circlip by squeezing the tabs together
and clipping into place.
We recommend cleaning with a soft dry cloth.
Do not use solvents or abrasive cleaners as these could
damage the finish.
Recycling advice
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling advice.
Safety information
For your safety, always switch off the supply before changing lightbulbs, or cleaning.
www.saxbylighting.com
AR111
Halogen Bulb
Iss.1 03012014
Saxby Lighting Ltd. BH23 3PE
Instruction leaflet
Remano Recessed
10430, 10431
Need help?
Do you have a question about the 10430 and is the answer not in the manual?
Questions and answers