KeyWest Technology MegaHertz The Protector Operation Manual page 24

Protector Operation Manual
MegaHertz
Now, you should see two programmed lines on your EVENT CONTROLLER. EVENT 1 as we
described previously—set to start the compressions and SEQ FOLLOW every weekday—and
now EVENT 2, set to end the compressions in the PM by going to GPI 1 OFF mode. Both event
lines should have the numbered indicators to their left illuminated green (fig. 25).
Figure 25
Is this all correct? If so, let's move on to see it work...if not, backtrack through the above steps
and make the necessary corrections.
In the lower right corner of the EVENT CONTROLLER you'll see a small circle, and above it is
a button labeled RESET INDICATOR (fig. 26).
Figure 26
This little circle is an aid for you to verify that the Protector can tell accurate time, and can
communicate with the VP boards. Whenever an event occurs (the time and days you
programmed) this circle will turn red. If the circle does not turn red, then we need to revisit our
settings (days of week, months, AM/PM, etc...) (fig. 27).
Figure 27
Keywest Technology
24
th
14563 W. 96 Terrace
Lenexa, Kansas 66215
10 July 2000
800.331.2019
www.keywesttechnology.com