3 Maintenance And Epair Ualification; Lectrical Cables; Sing A Generator - DYNAMIC DIAMOND TOOLING Beast User Manual

Dynamic Diamond Tooling
2.3 Maintenance and Repair Qualification
Maintenance and repair of the machine must onl be made b a D namic Diamond Tooling
certified service technician or authori ed representative
2.4 Electrical Safety
The electrical power source must be e uipped with fuses as specified in the "Electrical
Specifications" Table 1 1 All cables must be marked and rated according to the fuses
used
ever connect the machine to a power source that does not provide protective earth
ork on electrical e uipment should onl be undertaken b a skilled electrician or b a trained
person under the supervision of a skilled electrician as well as in accordance with local electrical
regulations
se e tension cables that are used for e tending the main cable and are si ed and marked in
accordance with the overall power consumption of the machine
se tools that are insulated against electricit
2.4.1 Electrical Cables
nl use cables that are marked and rated according to the specifications in "Electrical
Specifications" Table 1 1 . Do not use e cessive length of electrical cables
in a loop when operating the machine this will cause the cable to heat up and ma cause a fire
See Figure 2-1 for e planation
Figure 2-1 ecommended wa to handle e cessive cable length
2.4.2 Using a Generator
It is imperative to ensure that the Generator oltage hase Selector switch is correctl
matched to the machine voltage phase as shown in the "Electrical Specifications"
Table 1 1
Page 6
DDG 1220 User Manual
ever la the cable