2 Unning The Machine - DYNAMIC DIAMOND TOOLING Beast User Manual

Dynamic Diamond Tooling
4.2.6 Running the Machine
4.2.6.1 START
How to start the machine
nsure that the power plug and dust collector hose are connected to the
machine
Turn the dust collector
Set the Speed Control nob to its lowest speed setting
Make sure that the ST
release it b turning it a uarter turn clockwise until it rises
ush the handle downwards to lift the machine about 1 cm 4 from the
ground
ress the STA T 3 button
Lower the machine down to the floor
4.2.6.2 STOP
How to stop the machine
ress the ST
ait for the machine to come to a complete stop before letting go of the handle
Turn FF the dust collector if used
4.2.6.3 Adjusting grinding speed
Turn the S
counter clockwise to decrease the grinding speed
4.2.6.4 Change grinding direction
se the L
grinding direction Turn the machine FF and ensure that it has come to a complete stop
and then restart in the selected direction
if used
button 4 is in its upper most position If not
4 button
D C T L knob 2 clockwise to increase the grinding speed and
switch 1 to change the rotation of the motor and thereb selecting the
Page 29
DDG 1220 User Manual