DYNAMIC DIAMOND TOOLING Beast User Manual page 36

Dynamic Diamond Tooling
4.3.7 Running the Machine Overview
CHECKLIST
nsure the machine is plugged in to the correct power suppl
nsure the vacuum hose is connected and the vacuum turned
nsure ST
nsure S
ith the machine flat on the floor ensure that the dust shroud is flat to the floor
and has a good seal on the floor
nsure that the grinding head L
Set the operator handle to the most comfortable working height and tilt using the
handle adjustment settings
ush the handle downwards to lift the machine about 1 cm 4 from the ground
ress the STA T button
Lower the machine down to the floor and begin G I DI G
switch is in its upper most position
D C T L switch does not e ceed 7
L B BBL is in the centered position
Page 30
DDG 1220 User Manual