Operation - Hilti TE DRS 4/6 Manual

Weight
With TE6-22
With TE4-22
5

Operation

5.1 Preparations at the workplace
WARNING
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.2 Installing the Hilti retaining strap (optional)
ATTENTION
Damage to the product and / or the retaining leash. Incorrect handling can result in damage to the
product and/or retaining leash.
▶ Do not use a metal chain as a retaining leash. Do not use a retaining leash with a length of more than
2,0 m (6 ft).
To avoid damage and injury, when working at a height it is advisable to use the Hilti retaining strap.
The retaining strap allows the tool retaining leash to be attached.
When working with the product, you must comply with national regulations for working at heights.
1. Insert the two tabs on the retaining strap into the slots on each side of the DRS dust removal module.
2. Secure the retaining strap with the screws supplied.
3. Loop the Hilti retaining leash through the retaining strap.
5.3 Fitting the dust removal module
Before fitting the module, check that the attachment points and the electrical interfaces on the rotary
hammer drill and dust removal module are free of dust and that the parts fit or move freely and easily.
1. Set the forward / reverse selector switch on the rotary hammer drill to the middle position.
2. Remove the depth gauge from the side handle.
3. Position the dust removal module on the guides and from the front, push it on to the power tool until it
engages.
4. After fitting, check that the dust removal module is secure.
*2290879*
0 kg
(0 lb)
TE-CX XX/17 80 mm
(3.1 in)
TE-CX XX/15 60 mm
(2.4 in)
TE-CX X" x 6" 80 mm
(3.1 in)
TE-CX XX/22 110 mm
(4.3 in)
TE-CX XX/17 57 mm
(2.2 in)
TE-CX X" x 8" 110 mm
(4.3 in)
2
3
2290879 English 5