Operation - Hilti NURON TE 2000-22 Original Operating Instructions

Observe the safety instructions and warnings in this documentation and on the product.
5.1 Charging the batteries
1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery. → page 6
5.2 Inserting batteries
WARNING
Risk of injury by short circuit or falling battery!
▶ Before inserting the batteries, make sure that the contacts on the batteries and the contacts on the
product are free of foreign matter.
▶ Make sure that the batteries always engage correctly.
1. Charge the batteries fully before using them for the first time.
2. Push the batteries into the product until they engage with an audible click.
3. Check that the batteries are seated securely.
5.3 Removing the battery
1. Press the battery release button.
2. Remove the battery from the product.
6

Operation

Observe the safety instructions and warnings in this documentation and on the product.
6.1 Inserting the accessory tool
1. Lightly grease the connection end of the accessory tool.
The use of unsuitable grease can cause damage to the product. Use only genuine Hilti grease.
2. Push the accessory tool into the chuck as far as it will go, turning it and applying light pressure until it
engages with an audible click.
3. Check that the chisel has engaged correctly by gripping and pulling it.
6.2 Removing the accessory tool
CAUTION
Risk of injury! The accessory tool may be hot and/or have sharp edges.
▶ Wear protective gloves when changing the accessory tool.
▶ Never lay down a hot accessory tool on a flammable surface.
1. Pull the accessory tool retaining bar back as far as it will go.
2. Remove the accessory tool.
6.3 Operation
Observe the safety instructions and warnings in this documentation and on the product.
Full approval must be obtained from the site engineer or architect prior to beginning the work.
6.3.1 Chiseling
1. Position the tip of the chisel at the desired location.
*2301751*
3
4
2301751 English 9