1-Gb Network Module With Hardware Bypass - Cisco Firepower 2100 Series Hardware Installation Manual

1-Gb Network Module with Hardware Bypass

Cable and operating
distance
1-Gb Network Module with Hardware Bypass
The following figure shows the front panel view of the 1-Gb network module with hardware bypass
(FPR-NM-8X1G-F). Pair ports 1 and 2, 3 and 4, 5 and 6, and 7 and 8 to form hardware bypass paired sets.
Note
Make sure you have the correct firmware package and software version installed to support this network
module. See
for the procedure to verify your firmware package and software version. See
Platform Mode FXOS Configuration Guide
2100 running ASA with FXOS.
Figure 18: FPR-NM-8X1G-F
Cisco Firepower 2100 Series Hardware Installation Guide
26
Core diameter (microns)
G.652
Cisco FXOS Troubleshooting Guide for the Firepower 1000/2100 with Firepower Threat Defense
Modal bandwidth
(MHz/km)
Single mode
for the procedure to upgrade the firmware package for the Firepower
Overview
Cable distance
Half the
Note
distance
specified by
the IEEE
standard.
5 km
Cisco Firepower 2100 ASA