Cisco Firepower 2100 Series Hardware Installation Manual page 36

Supported SFP/SFP+ Transceivers
Warning
Statement 1055 Class 1/1M Laser
Invisible laser radiation is present. Do not expose to users of telescopic optics. This applies to Class 1/1M
laser products.
Warning
Use appropriate ESD procedures when inserting the transceiver. Avoid touching the contacts at the rear, and
keep the contacts and ports free of dust and dirt. Keep unused transceivers in the ESD packing that they were
shipped in.
Note The 1-Gb transceivers are limited to 1-Gb operation only (no autonegotiation support). 100-M/10-M modes
are not supported.
Caution Although non-Cisco SFPs are allowed, we do not recommend using them because they have not been tested
and validated by Cisco. Cisco TAC may refuse support for any interoperability problems that result from
using an untested third-party SFP transceiver.
The following table lists the supported transceivers.
Table 7: Supported SFPs
Optics Type
SFP 1Gb
1G-SX
1G-LH
1G-EX
1G-ZX
1G 1000Base-T
1G 1000Base-T
SFP+ 10Gb
Cisco Firepower 2100 Series Hardware Installation Guide
32
PID
GLC-SX-MMD
GLC-LH-SMD
GLC-EX-SMD
GLC-ZX-SMD
GLC-T
GLC-TE
Ports Supported
Ports 13 through 16
Ports 1 though 8 of the 8X10G network
module (available only on the 2130 and 2140)
Supported on the Firepower 2130 and 2140.
Supported on the Firepower 2130 and 2140.
Overview