Safety Recommendations - Cisco Firepower 2100 Series Hardware Installation Manual

Installation Preparation
Warning
Statement 7012 Equipment Interfacing with AC Power Ports
Connect this equipment to AC mains that are provided with a surge protective device (SPD) at the service
equipment that complies with NFPA 70, the National Electrical Code (NEC).
Note
Statement 7013 Equipment Grounding Systems—Common Bonding Network (CBN)
This equipment is suitable for installations using the CBN.
Note
Statement 7016—Battery Return Conductor
Treat the battery return conductor of this equipment as DC-I.
Note
Statement 7018 System Recover Time
The equipment is designed to boot up in less than 30 minutes provided the neighboring devices are fully
operational.
Note
Statement 8015 Installation Location Network Telecommunications Facilities
This equipment is suitable for installation in network telecommunications facilities.
Note
Statement 8016 Installation Location Where the National Electric Code (NEC) Applies
This equipment is suitable for installation in locations where the NEC applies.

Safety Recommendations

Observe these safety guidelines:
• Keep the area clear and dust-free before, during, and after installation.
• Keep tools away from walkways, where you and others might trip over them.
• Do not wear loose clothing or jewelry, such as earrings, bracelets, or chains that could get caught in the
• Wear safety glasses if you are working under any conditions that might be hazardous to your eyes.
• Do not perform any action that creates a potential hazard to people or makes the equipment unsafe.
chassis.
Cisco Firepower 2100 Series Hardware Installation Guide

Safety Recommendations

47